I have darwin osx86 with the 10.4.5 upgrade and all the patches. i orginally installed it nativly on my second hard drive and it installed like a champ,but when i booted my mouse would not work i would get the message about the appleps/2controller.kext so i was finally able to figure out all the keyboard shortcuts and get into the keyboad/mouse menu and set it to use the numberpad on the keyboard as the mouse. worked like a charm but a littlebit of a pian in hind end,but all was great untill i rebooted and then the keyboard would not work. i did extensive searching and tried every patch and solution offered on insanlymac forums. NO DICE! now my problem is that when i try to install it to a partition on my second drive using VMWARE WORKSTATION the install goes fine until it reboots and then it tells me that my processor as been disabled by guestOS, i installed it the same way as before with the same patches (SSE2,intel base, and one for the sata,pata,and via chipset) why is it not working now? i believe the copy i have is 10.4.4 with the option to upgrade to 10.4.5 any help would be greatly appreciated i have tried the solutions here but they are not working.
i installed this like 2 weeks ago but havent had the time to type out this post/thanks/guide. remember this install method worked for me on my system. chances are you dont have my exact system, im posting cause i surf osx86 forums looking for posts like this to check out someone elses hardware config and seeing what worked for them. so i will walk you through the process i did, keep in mind it could have been done more efficiently cause i didnt have the 10.6.7 updater til later.
OSX86 ISO HAZARD.torrent
DOWNLOAD: https://jinyurl.com/2vIvgG
2ff7e9595c
Comments